Manual

Alert Vest – Manual

Activate / on - 1 click

Lights (disabled if your vest comes without lights)
2 clicks – lights on
2 clicks – flashing lights
2 clicks – rythmic flashing lights
1 long click (hold 2 seconds) – lights off (but vest is still on).

Lights automatically on/off when entering or exiting a work vehicle is possible to set in the app. This is triggered by the AI with a recognition percentage of approx 75%.

For safety precautions, in case the electronic collar snaps are disconnected from the vest collar snaps, the lights will not work, however all other functions work normally.

Turn off - 1 long click 5 seconds

Alarm -5 clicks to trigger the alarm manually (max half a second between clicks). Countdown 30 seconds start.

Note:

• The Alarm is not sent if you cancel the alarm while countdown in the app.
• No alarm is sent if the vest is not connected to a smartphone with SIM card.
• The fall alarm is triggered automatically by the AI in the vest electronics.
• The timer alarm is set in the Sense app.

Battery status
The LED in the button shows the battery status every 10 seconds.
The color indicates the battery status:

Green: over 40
Blue: between 20% - 40%
Red: under 20%.

When vest is activated you can click once on the button to see battery percentage.

The battery charge indication is automatically calibrated during the first 3 charging cycles.

During charging, the light indications are the following: ljusindikationer:

Green light: over 90%.
Blue light: 60-90%
Red light: 0 % – 60

SOUNDS
ON: low-to-high beep tone.
OFF: high-to-low beep tone.
ONE BEEP: bluetooth connection established between phone and vest or lights turned off.
ONE LOW PITCH BEEP: bluetooth connection lost.

SILENT MODE
When activating, keep the button pressed for 4 seconds until you hear a longer beep.
To deactivate silent mode, turn off the electronic collar then turn on by pressing the button 4 seconds.

These settings can also be set in the Sense app.